Model	Description	Brand	Leading	Condition
Power Management
AL8860MP-13	The AL8860 is a hysteresis mode DC/DC step-down converter, designed for driving single or multiple series connected LEDs efficiently from a voltage source higher than the LED voltage. The device can operate from an input supply between 4.5V and 40V and provide an externally adjustable output current up to1A for TSOT25 package and 1.5A for MSOP-8EP package. Depending upon supply voltage and external components, this converter can provide up to 40 watts output power.	OTHER	In Stock	QB全新保内
AP7366-33W5-7	The AP7366 is a 600mA, adjustable and fixed output voltage, low dropout linear regulator. This device includes pass element, error amplifier, band-gap, current limit and thermal shutdown circuitry. The device is turned on when EN pin is set to logic high level.The characteristics of low dropout voltage and low quiescent current make it suitable for low power applications such as battery powered devices. The typical quiescent current is approximately 60µA. Built-in current-limit and thermal-shutdown functions prevent IC from damage in fault conditions.This device is available with adjustable output from 0.8V to 5.0V, and fixed version with 1.0V, 1.2V, 1.5V, 1.8V, 2.0V, 2.5V, 2.8V, 3.0V, 3.3V and 3.9V outputs. Please contact your local sales office for other voltage options.The AP7366 is available in SOT25 and U-DFN2020-6 packages.	OTHER	In Stock	QB全新保内
AZ1117H-3.3TRE1	The AZ1117 is a series of low dropout three-terminal regulators with a dropout of 1.15V at 1A output current.The AZ1117 series provides current limiting and thermal shutdown.Its circuit includes a trimmed bandgap reference to assure output voltage accuracy to be within 1% for 1.5V, 1.8V, 2.5V, 2.85V, 3.3V, 5.0V and adjustable versions or 2% for 1.2V version. Current limit is trimmed to ensure specified output current and controlled short-circuit current. On-chip thermal shutdown provides protection against any combination of overload and ambient temperature that would create excessive junction temperature.	OTHER	In Stock	QB全新保内
AP2125K-1.8TRG1	300MA, High Speed, Extremely Low Noise CMOS LDO Regulator. The AP2125 series are 300mA, positive voltage regulator ICs fabricated by CMOS process. Each of these ICs is equipped with a voltage reference, an error amplifier, a resistor network for setting output voltage, a chip enable circuit, a current limit circuit and OTSD (over temperature shut down) circuit to prevent the IC from over current and over temperature. The AP2125 series have features of high ripple rejection, low dropout voltage, low noise, high output voltage accuracy and low current consumption which make them ideal for use in various battery-powered apparatus. The AP2125 have 1.8V, 2.5V, 2.8V, 3.0V, 3.3V, 4.15V and 4.2V fixed voltage versions. Application(s)· CDMA/GSM Cellular Handsets · Battery-powered Equipments · Laptops, Palmtops, Notebook Computers · Hand-held Instruments · PCMCIA Cards · Portable Information Appliances	OTHER	In Stock	QB全新保内
AP2204K-ADJTRG1	The AP2204 series is a positive voltage regulator IC fabricated by high voltage EPNP process.The AP2204 has features of wide input voltage range, high accuracy, high ripple rejection, low dropout voltage, low noise, current limit and ultra-low quiescent current which make it ideal for use in various USB and portable devices.The IC consists of a voltage reference, an error amplifier, a resistor network for setting output voltage, a current limit circuit for current protection, and a chip enable circuit.The AP2204 has 1.5V, 1.8V, 2.5V, 2.8V, 3.0V, 3.3V, 5.0V fixed voltage versions and adjustable voltage version.The AP2204 is available in space-saving SOT-23-5, SOT-89 and PSOP-8 packages. Applications Battery-powered Equipment Laptop, Palmtops, Notebook Computers Portable Information Appliances	OTHER	In Stock	QB全新保内
AP3125AKTR-G1	DescriptionThe AP3125X is a current mode PWM controller which is optimized for high performance, low standby power and cost effective offline fly-back converters. It is available in SOT26 package.The PWM switching frequency at normal operation is internally fixed (about 65kHz/100kHz). In middle load, IC will enter green mode to improve system efficiency with the help of frequency fold-back. A minimum switching frequency (about 20kHz) is set to avoid the audible noise. In no load or light load, the IC will enter the burst mode to minimize standby power. Furthermore, the frequency dithering function is built-in to reduce EMI emission.Internal slope compensation allows more stable Peak-Current Mode control over wide range of input voltage and load conditions. Internal line compensation ensures constant output power limit over entire universal line voltage range.Comprehensive protection features are included, such as cycle-by-cycle current limit (OCP), VCC Over Voltage Protection (VOVP), internal OTP, Over Load Protection (OLP) and pins’ fault protection.The versatile latch/auto functions can be implemented using a minimal number of external components by CTRL pin.Application(s)Switching AC-DC Adapter/ChargerATX/BTX Auxiliary PowerSet-top Box (STB) Power SupplyOpen Frame Switching Power Supplys	OTHER	In Stock	QB全新保内
AP4340LNTR-G1	The AP4340 is an output voltage detector for Primary Side Control System. It detects the output voltage and provides a periodical signal when the output voltage is lower than a certain threshold. The periodical signal can be coupled by the transformer to the primary side and provided as an awakening signal for the main primary side controller. By fast response to secondary side voltage, the AP4340 can effectively improve the transient performance of Primary Side Control System. The AP4340 is available in TO-92 and SOT-23 packages. Applications · Adapters/Chargers for Cell/Cordless Phones, ADSL Modems, MP3 and Other Portable Apparatus · Standby and Auxiliary Power Supplies	OTHER	In Stock	QB全新保内
AP62200WU-7	DescriptionThe AP62200 is a 2A, synchronous buck converter with a wide input voltage range of 4.2V to 18V. The device fully integrates a 90mΩ high-side power MOSFET and a 65mΩ low-side power MOSFET to provide high-efficiency step-down DC/DC conversion.The AP62200 device is easily used by minimizing the external component count due to its adoption of Constant On-Time (COT) control to achieve fast transient response, easy loop stabilization, and low output voltage ripple.The AP62200 design is optimized for Electromagnetic Interference (EMI) reduction. It has a proprietary gate driver scheme to resist switching node ringing without sacrificing MOSFET turn-on and turnoff times, which reduces high-frequency radiated EMI noise caused by MOSFET switching.The device is available in a SOT563 or TSOT26 package. Application(s)Flat Screen TV Sets and MonitorsSet Top BoxesConsumer ElectronicsNetwork SystemsGeneral Purpose Point of Load	OTHER	In Stock	QB全新保内
AP7343D-28FS4-7B	The AP7343 is a low dropout regulator with high output voltage accuracy, low RDSON, high PSRR, low output noise and low quiescent current. This regulator is based on a CMOS process.The AP7343 includes a voltage reference, error amplifier, current limit circuit and an enable input to turn it on and off. With the integrated resistor network fixed output voltage versions can be delivered.With its low power consumption and line and load transient response, the AP7343 is well suited for low power handheld communication equipment.The AP7343 is packaged in an X2-DFN1010-4 package and allows for smallest footprint and dense PCB layout. Application(s)Smartphone/TabletRF SupplyCamerasPortable VideoPortable Media PlayerWireless AdapterWireless Communication	OTHER	In Stock	QB全新保内
AP7361-15ER-13	The AP7361 is a 1A, adjustable and fixed output voltage, ultra-low dropout linear regulator with enable. The device includes pass element, error amplifier, band-gap reference, current limit and thermal shutdown circuitry. The device is turned on when the EN pin is set to logic high level. The characteristics of the low dropout voltage and low quiescent current make it suitable for low to medium power applications, for example, laptop computers, audio and video applications, and battery powered devices. The typical quiescent current is approximately 70µA. Built-in current-limit and thermal-shutdown functions prevent IC from damage in fault conditions. The AP7361 is available in U-DFN3030-8, SOT89-5, SOT223, TO252 and SO-8EP package. Applications Servers and Laptops FPGA and DSP Core or I/O Power TV, and Home Electrical Appliances Battery-Powered Device	OTHER	In Stock	QB全新保内
AZ1117CH-2.5TRG1	The AZ1117C is a low dropout three-terminal regulator.The AZ1117C has been optimized for low voltage where transient response and minimum input voltage are critical. It provides current limit and thermal shutdown. Its circuit includes a trimmed bandgap reference to assure output voltage accuracy to be within ±1%. On-chip thermal shutdown provides protection against a combination of high current and ambient temperature that would create excessive junction temperature.The AZ1117C is available in 1.2V, 1.5V, 1.8V, 2.5V, 3.3V, 5.0V fixed output voltage versions and ADJ output voltage version. The fixed versions integrate the adjust resistors. It is also available in an adjustable version which can set the output voltage with two external resistors.The AZ1117C is available in the industry-standard TO2522 (3), TO2522 (4), and TO2522 (5), SOT89-3L and SOT223 power packages. Application(s)USB Device Add-On Card DVD Player PC Motherboard	OTHER	In Stock	QB全新保内